Amana Tool 54278 Carbide Tipped Raised Panel Back Cutter 1/4 R x 1-3/4 D x 7/16 CH x 1/2 Inch SHK Router Bit

Amana Tool® Item #54278
$56.70
$42.53
Free shipping on orders $49 and up
Designed to cut back side of raised panels for a flush alignment with door frames. This cutter can be used with any of our raised panel router bits.

 Watch now! How to make Raised Panel Doors
?WARNING!

For Your Safety
1. The methods illustrated here are only
    intended for use with a table mounted
    router.
2. Do not exceed the recommended RPM for
    each of the bits.
3. Use a miter gauge and clamp when     routing the ends of the rails.
4. Use a push block or push stick when
    routing the door styles.
5. Use a guard at all times.
6. Use eye and hearing protection.
7. Do not use the methods in this set of
    instructions unless you feel that they are 
    safe for you. 

Router Bits shown in video
Stile & Rail Router Bits
Reversible Stile & Rail Assembly - #55350
2pc Concave Stile & Rail - #55420 & #55421

Raised Panel Router Bits
Ogee Raised Panel - #54118
Ogee Raised Panel w/Back Cutter - #54221
 
WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.
Copyright © 2020 Toolstoday. All rights reserved.