Amana Tool DT14108-30 Carbide Tipped Sliding Table Saw 14 Inch D x 108T ATB, 10 Deg, 30MM Bore, Circular Saw Blade
Instructions for grinding:
• For maintenance grinding, use fine grit (D400 to D600) diamond wheels. To match the factory grind, use a slower than normal feed rate.
• Damaged teeth can be replaced, however, replacing of a large number of teeth will, of course, shorten the life of the saw blade.
• Since the carbide in the DITEC™ is harder than other carbides, it is critical that you protect them from “thermal shock” if an adjacent tooth is replaced. Heat absorbed during the brazing process will seriously degrade the DITEC™ carbide.
*Please note #DT300T96-30C is coated with Electro-Blu™ Non-Stick Coating
Safety Guidelines for Saw Blades.