Timberline 420-50 Carbide Tipped Ogee Raised Panel with Back Cutter 7/8 R x 3-3/8 D x 1-3/16 CH x 1/2 Inch SHK Router Bit
Similar to standard horizontal raised panel bits, but with back cutter to cut inside of the panel. Includes two different bearings to allow for safer two-pass operation. Carbide Tipped. Use with router table only.
| Watch now! How to make |
Raised Panel Doors
For Your Safety
1. The methods illustrated here are only
intended for use with a table mounted
2. Do not exceed the recommended RPM for
each of the bits.
3. Use a miter gauge and clamp when routing the ends of the rails.
4. Use a push block or push stick when
routing the door styles.
5. Use a guard at all times.
6. Use eye and hearing protection.
7. Do not use the methods in this set of
instructions unless you feel that they are
safe for you.
Router Bits shown in video
Stile & Rail Router Bits
Reversible Stile & Rail Assembly - #55350
2pc Concave Stile & Rail - #55420 & #55421
Raised Panel Router Bits
Ogee Raised Panel - #54118
Ogee Raised Panel w/Back Cutter - #54221