Cut decorative carvings and lettering on signs with these carving bits
Cost of 5 bits
Purchased Individually | $239.20 |
| Set Selling Price | $179.40 |
| Buying the Set you Save | 25% |
Benefits of ZrN Coating:
- Creates incredibly precise detail work
- Optimized flute geometry and low Total Indicated Runout (TIR) guarantees clean cuts, essentially eliminates sanding and reduces chatter when used with low TIR spindles
- Creates a harder and tougher cutting ceramic over carbide edge, allowing for a prolonged cutting edge life and helps to prevent the build-up/galling of material in the flutes while cutting
- PVD ceramic hardcoat designed for soft, gummy and abrasive materials
- High aspect ratio for single pass deep-reach cutting
- High flute volume supports high feed rates and chip loads. Has the ability to run and/or be spun much faster than uncoated tools
- Flute geometry optimized for cutting sign foam, sign board, hardwoods, thermoplastics and phenolic composites
Spektra™ bits feature a nACo® nanocomposite coating with an extreme nanohardness and heat resistance to the router bit. With a brilliant distinctively-tinted coloring nACo provides additional improvements in four critical aspects of router tooling.
- nACo coating is an micro-thin ceramic coating which enables the tool's cutting edge to retain crucial sharpness and lubricity. This provides longevity and produces cutting results of the highest quality.
- Coatings prevents high heat and oxidation which is detrimental to cutting tool performance.
- Multi-colored hues, while attractive, will dissipate upon use and yet coating will remain fully effective.
- nACo offers approximately 4,500 Vickers for impressive solid hardness on cutting areas of the tool, for an increase up to 2.5 times compared to uncoated bits.
Note: Blue based color dissipates immediately upon use. nACo® nanocomposite coating will not wear off.
Excellent for Cutting:
- Acrylic
- Composites
- Composite Decking
- Foam
- Laminate
- Melamine
- MDF/HDF
- Plywood
- PVC Plastic
- Sign Board
- Solid Surface
- 20lbs High Density Urethane
- Veneered Plywood
- Wood
- Xanita® Board
