Amana Tool 51463 SC Spiral for Steel, Stainless Steel & Non Ferrous Metal with AlTiN Coating 2-Flute x 3/16 D x 3/8 CH x 3/16 SHK x 2-1/2 Inch Long Up-Cut Router Bit / 45 Deg Corner Chamfer End Mill
Amana Tool 51463 SC Spiral for Steel, Stainless Steel & Non Ferrous Metal with AlTiN Coating 2-Flute x 3/16 D x 3/8 CH x 3/16 SHK x 2-1/2 Inch Long Up-Cut Router Bit / 45 Deg Corner Chamfer End Mill
Amana Tool 51463 SC Spiral for Steel, Stainless Steel & Non Ferrous Metal with AlTiN Coating 2-Flute x 3/16 D x 3/8 CH x 3/16 SHK x 2-1/2 Inch Long Up-Cut Router Bit / 45 Deg Corner Chamfer End Mill
These 2, 3 and 4 flute industrial solid carbide router bits are manufactured from Amana Tool®'s exclusive ultra-fine micrograin carbide and feature a 30 degree Center Cutting Mill End, a corner chamfer (for extra strength), Up-Cut design and very importantly, the Aluminum Titanium Nitride (AlTiN) Coating.
Increase the ruggedness of your solid carbide endmill's number one major wear point by the addition of corner chamfers that enhance the edge strength.
Excellent for use in a broad range of materials including:
Stainless Steel
Steel
Cast Iron
Composites
Low Carbon Steel
Magnesium
Metal Composite Material (MCM)
Non-Ferrous Metals
Plastics
Super Alloys
Titanium (up to 40HRc Hardness)
Perfect for the signmaking industry.The special carbide grade combined with the AlTiN coating gives amazing performance. The unique corner chamfer gives the bits great strength. These bits are available in several sizes. Read a woodworker's review of these bits.
AlTiN Coating Benefits:
Extra wear resistance
Allows for faster feed and speed rates
Cutting edge protected from wear
Better chip evacuation
Less heat build up
Superior cutting quality and extended tool life
WARNING! Inspect cut quality and adjust feed and speed accordingly. Care should be taken to observe proper feeds and speeds according to the workpiece material to avoid damage.Note: For optimal results and extended tool life use mist lubricant system or air cooling.
WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.
AlTiN Coated Router Bits used to Create American Eagle Brass Medallion