Amana Tool RC-2250 Insert Mini Surfacing & Rabbeting Flycutter 2+2 Flute Design 1-1/2 D x 1/2 CH x 1/2 Inch SHK Router Bit, Includes 2 Each of HMA-12 and HCK-70

Amana Tool® Item #RC-2250
$198.30
$178.47
Free shipping on orders $49 and up


vectric fusion 360 tool file toolstoday


vectric fusion 360 tool file toolstoday

MDF-Grade solid carbide insert knives included. Optional general purpose knives available below. 

Mini insert spoilboard surfacing & rabbeting with scorers, great for cutting tight corners. Features unique 2+2 insert knife design that contains two cutting flutes and two up-shear scorers, which provide a smoother finish at the bottom of the cut than traditional two-knife style router bits. Engineered with an Amana-exclusive carbide grade for the highest quality of cut, maximum cutting efficiency, and faster material removal process. Also known as a Surface Planing, Rabbeting, Flycutter, Fly Cutter, Leveler and Bed Skimming Router Bit.

Perfect for:

  • Resurfacing spoilboards using CNC
  • 2+2 spoilboards contain two bottom scorers for better performance, finer surface finish and better clearance for 90? corners
  • Planing large glued up panels using  CNC
  • Surfacing and finishing wood using timber slab machines
  • Also suitable for router sled machines, Make sure that your router sled is fully stable and squared.
  • Rabbeting or slotting
Also suitable for router sled machines, Make sure that your router sled is fully stable and squared.

These industrial router bits come complete with four (4) MDF-Grade solid carbide insert knives, each with four (4) cutting edges that allow users to rotate the knife when one side becomes dull. Designed for spoil boarding, planing & rabbeting the following materials:

  • MDF 
  • Fiberboard
  • HDF/LDF
  • High Density Urethane (HDU Board)
  • Balsa Core*
  • Plastic/Acrylic**
  • Plywood/Chipboard*
  • Solidwood/Softwood*
  • Ultra-High-Molecular-Weight Polyethylene (UHMWPE)

*For optimal results and maximum insert life, replace inserts with optional general purpose knives #AMA-12 and #RCK-70 (sold separately).

**Use lower CNC spindle RPM and adjusted feed-rate to prevent Melting and adhesion of the acrylic material to the tool.

Max RPM = 24,000.

Recommendations: For surfacing solid woods it is recommended to remove both bottom scorers.

Note: This tool is not designed to plunge! You must ramp down to a depth of 1/4" deep over a 20" run. Use the max RPM allowed and start with the feed rate (from the speed and feed chart), and go up until you get waves, then back down to a smooth cut/finish.
WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.
Copyright © 2020 Toolstoday. All rights reserved.