Raised Panel Back Cutter Router Bits
*Sort the Table by clicking on the Column Heading
| D | B | d | L | R | A | Ball Bearing | Replacement Bearing | Brand | Tool No | Our Price | Wish List | Ready To Buy | |||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 1-3/4 | 7/16 | 1/2 | 2-1/16 | 1/4 | 5/8 | Yes | 47706 | Amana Tool 54278 Carbide Tipped Raised Panel Back Cutter 1/4 R x 1-3/4 D x 7/16 CH x 1/2 Inch SHK Router BitMore info | Amana Tool | 54278 | $64.65$48.49 |
Note: 'A' reflects the total length of cut. Therefore you must deduct (usually 3/8") for allowing the panel to recess into the frame.
Designed to cut back side of raised panels for a flush alignment with door frames. This cutter can be used with any of our raised panel router bits.
| Watch now! How to make Raised Panel Doors | ?WARNING! For Your Safety 1. The methods illustrated here are only intended for use with a table mounted router. 2. Do not exceed the recommended RPM for each of the bits. 3. Use a miter gauge and clamp when routing the ends of the rails. 4. Use a push block or push stick when routing the door styles. 5. Use a guard at all times. 6. Use eye and hearing protection. 7. Do not use the methods in this set of instructions unless you feel that they are safe for you. Router Bits shown in video Stile & Rail Router Bits Reversible Stile & Rail Assembly - #55350 2pc Concave Stile & Rail - #55420 & #55421 Raised Panel Router Bits Ogee Raised Panel - #54118 Ogee Raised Panel w/Back Cutter - #54221 |
WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.