PCD Diamond Flush Trim Router Bits-2 Flute

Priced From
$93.11
-
$137.57
Free shipping on orders $49 and up
SEE OPTIONS BELOW
$103.45
$93.11
*Sort the Table by clicking on the Column Heading
DBdLFluteTypeBall BearingReplacement BearingHex NutUse w / Screw no.WasherBrandTool NoOur PriceWish ListReady To Buy
1/27/161/42-19/642PCD Diamond*Lower4770667135 67018-
Amana Tool DRB-400 PCD Diamond Tipped Flush Trim 1/2 D x 7/16 CH x 1/4 SHK x 2-19/64 Inch Long Router Bit w/ Lower Ball BearingMore infoAmana ToolDRB-400$103.45$93.11
Qty:
1/211/42-53/642PCD DiamondLower47706671356709667082 (Lock Washer) and 67098 (Dust Shield)
Amana Tool DRB-404 PCD Diamond Tipped Flush Trim 1/2 Dia x1 Inch Cut Height x 1/4 Inch Shank w/ Lower Ball Bearing Router BitMore infoAmana ToolDRB-404$152.85$137.57
Qty:

The ultimate flush trim bit. The diamond-tipped cutting edges last at least 25 times longer than carbide-tipped flush trims, saving you the time and money. Can be used for flush trimming aluminum sandwich materials such as Aluminum Composite Material (ACM), ALPOLIC® Copper Composite Material (CCM), Alucobond®, Alupanel®, Dibond®, Durabond®, Titanium Composite Material (TCM) etc.

Diamond is the hardest material on the earth. Polycrystalline Diamond (PCD) tooling is manufactured in a high-temperature and high-pressure laboratory that fuses diamond particles onto a carbide substrate, which allows the diamond to be brazed onto a tool body.

PCD Tooling Benefits:

  • Harder cutting edge provides higher resistance to wear
  • Cut thousands of feet more than carbide without changing tool, saving setup time
  • Optimized machine tool efficiency
  • Quality of finish is often significantly improved
If you’re looking for the ultimate in tooling, you’ve found it! Amana Tool®'s PCD tipped Flush Trim router bits will cut and trim a wide variety of tough, abrasive materials including composites, laminate, aluminum, and wood. The cutting edge lasts much longer than carbide for extremely long life. Depending on the material being cut, PCD tooling has been known to out perform a carbide tool by a ratio of 300:1. However, to be conservative in your buying decision, we suggest you base your expectations on 25:1 ratio over carbide tooling.

Excellent for flush-trimming:

  • Aluminum
  • Aluminum Composite Material (ACM)
  • Aluminum Compsite Panel (ACP)
  • Composite Materials
  • Fiberglass PCD Board
  • Fiberglass Reinforced Composites
  • Fiber-Reinforced Structural Foam Floors
  • Fiber-Reinforced Urethane
  • Laminate
  • Lightweight Composites
  • Metal Laminate
  • MDF/Laminate
  • Wood
Warning: Not for CNC use!

WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.
Copyright © 2021 Toolstoday. All rights reserved.