Table Edge Router Bits - Ogee and Bead
*Sort the Table by clicking on the Column Heading
| D | Flute | B | B1 | L | R | d | B2 | Ball Bearing | Max RPM | R1 | Replacement Bearing | Brand | Tool No | Our Price | Wish List | Ready To Buy | |||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 2-1/2 | 2 | 25/32 | 43/64 | 2-3/4 | 13/32 | 1/2 | 7/64 | Lower | 16,000 | 13/64 | 47706 | Amana Tool 49556 Carbide Tipped Table Edge Classical 3/8 x 1/4 R x 2-1/2 D x 3/4 CH x 1/2 Inch SHK w/ Lower Ball Bearing Router BitMore info | Amana Tool | 49556 | $186.60$139.95 |
Cuts a shallow ogee into the tabletop surface coupled with a bead at the edge. Bit will produce a fillet if set to cut deep enough. With the optional 3/8" bearing, it will produce a fillet at the cut's edge. Good choice for handrails.
These special router bits are used for cutting table top edges or used with handrail side profile bits. Originally designed for easing and profiling the edges of tabletops, these bits also are widely used for the same purpose on handrails. See also handrail patterns. Eliminate hard edges, reduce the visual thickness of a tabletop, and add an elegant detail simultaneously with these bits.
These special router bits are used for cutting table top edges or used with handrail side profile bits. Originally designed for easing and profiling the edges of tabletops, these bits also are widely used for the same purpose on handrails. See also handrail patterns. Eliminate hard edges, reduce the visual thickness of a tabletop, and add an elegant detail simultaneously with these bits.
- Carbide tipped
- Maximum RPM 16,000
WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.