Solid Carbide Double Edge Folding V Groove Router Bits with AlTiN Coating for Shaping Titanium Composite Material (TCM) Panels

Priced From
$65.51
Free shipping on orders $49 and up
SEE OPTIONS BELOW
$87.35
$65.51
*Sort the Table by clicking on the Column Heading
DBdLa°1D1B1d1FluteTypeSurface CoatingBrandTool NoOur PriceWish ListReady To Buy
90°1/23/81/4245°0.09013/640.0902V GrooveAlTiN
Amana Tool 45762 SC AlTiN Coated V-Groove 90 Deg. Folding for Composite Material Panels Like TCM, CCM, ACM, 0.090 Tip Cut Width x 3/8 CH x 1/2 D x 1/4 Inch Steel SHK Router BitMore infoAmana Tool45762$87.35$65.51
Qty:

The Aluminum Titanium Nitride (AlTiN) coated solid carbide cutting tip is brazed to a steel shank specially designed to cut grooves in composite building materials such as:

  • Aluminum, Clay, Zinc & Wood Composite Panels
  • Aluminium Composite Materials (ACM)
  • Aluminium Composite Panel (ACP)*
  • ALPOLIC® Copper Composite Material (CCM)
  • Alucobond®
  • Alupanel®
  • Dibond®
  • Durabond**
  • e-panel™
  • Etalbond®
  • Metal Composite Material (MCM)
  • Phenolics
  • Plastic/Acrylic
  • Plexiglas®
  • Stainless Steel Composite Material (SCM)
  • Titanium Composite Material (TCM)
  • Wood


*Aluminum Composite Panel (ACP) is a type of ACM flat panel
that consists of two thin aluminium sheets bonded to a non-aluminium core and is widely used as cladding for many diverse applications such as interior and exterior office buildings, external cladding or facades of buildings, hospitals, convention centers, airports, hotels, insulation and signage. **Durabond is a polyethylene core with 0.3mm colored aluminum sheet on either side, pre-finished requiring no decoration. Routing V-shaped grooves, whereby the aluminum cover and a part of the polyethylene core is removed, allows folding the remaining material by hand.

Specially designed router bits are used to route V-grooves in the above materials to allow easy bending without cracking the bent area. Route within 0.8mm from the bottom of the composite panel to achieve a clean bend/radius. Routing V-shaped grooves, whereby the aluminum cover and a part of the polyethylene core is removed, allows folding the remaining material by hand. Ideal for wall panel fabrication.

AlTiN coating has many benefits:

  • Extra wear resistance
  • Allows for faster feed and speed rates
  • Cutting edge protected from wear
  • Better chip evacuation
  • Less heat build up
  • Superior cutting quality and extended tool life
WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.
Copyright © 2021 Toolstoday. All rights reserved.