This round-over router bit is designed for clean, precise edge profiling on both plastic edge banding and solid wood. It delivers smooth, consistent results for a refined edge finish on small and detailed workpieces. Its hollow, direct-thread design mounts straight onto the trim router shaft—no collet required—for stable, wobble-free cutting and excellent run-out accuracy. The result is a smooth, uniform round-over and a clean routing pattern with minimal setup and maximum control.
- Two cutting edges: Dual carbide cutting edges provide longer life and consistent cutting performance
- Round-over profile: Designed for clean, uniform edge rounding
- Precision-ground radius: Ensures smooth, accurate profiles and a consistent finished edge
- Low profile design: Allows routing in rabbets or across stacked panels
- Surface protection: The radius transitions into a 5° relief angle for smoother exits and reduced surface marking
- Ball bearing not included
- Collet-free, hollow-shaft design
- Carbide-tipped design
Main applications
- For rounding over plastic or solid wood edge banding
- For rounding over solid wood
Specifications
- R: 5/32" (4 mm)
- D: 1-1/16" (27 mm)
- No. of teeth: 2.00
Uses
- Forms smooth 4mm radius edge profiles.
- Adds decorative detail to furniture pieces.
- Enhances comfort on frequently touched surfaces.
- Creates consistent rounded edges repeatedly.
- Suitable for cabinetry and millwork tasks.
- Reduces chipping along routed edges.
