Carbide Tipped Brad Point Boring Bits - 70mm Long - 10mm x 30mm Shank-Left Hand
Priced From
$18.13
-
$58.42
Free shipping on orders $49 and up
$25.90
$18.13
BUY 5 OF THE SAME
SAVE 5%
Discount applied in your shopping cart
BUY 10 OF THE SAME
SAVE 10%
Discount applied in your shopping cart
*Sort the Table by clicking on the Column Heading
Note:
#304003 is solid carbide.
Note:
Right hand tools rotate clockwise. Left hand tools rotate counter-clockwise.
Note:
#301011 is replaced by #304011
#304016 is replaced by #304017
#304003 is solid carbide.
Note:
Right hand tools rotate clockwise. Left hand tools rotate counter-clockwise.
Note:
#301011 is replaced by #304011
#304016 is replaced by #304017
Industrial Brad Point Boring Bits are Coated with a Non-Stick Coating for Longer Lasting Cutting Edge and Tool Life.
Amana Tool® dowel drills are coated with a special Polytetrafluoroethylene (PTFE), a non-stick color coating. In cases where the carbide tip cutting edges are coated, there is no need to sand the coating off before use. Once the tool starts drilling, the coating is cleared off the needed cutting edge right away.
Amana's coating is applied onto the bit at a temperature of 570° F. The coating reduces the friction between the chip and the body inside the flute and it helps to clear the chips out of the hole during the drilling creating a cooler drilling area, no burning and longer lasting cutting edge.
Amana Tool® dowel drills are coated with a special Polytetrafluoroethylene (PTFE), a non-stick color coating. In cases where the carbide tip cutting edges are coated, there is no need to sand the coating off before use. Once the tool starts drilling, the coating is cleared off the needed cutting edge right away.
Amana's coating is applied onto the bit at a temperature of 570° F. The coating reduces the friction between the chip and the body inside the flute and it helps to clear the chips out of the hole during the drilling creating a cooler drilling area, no burning and longer lasting cutting edge.
Carbide Tipped Boring Bits - In Action!
WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.