Bowl & Sink Trim Router Bits w/ Ultra-Glide™ Ball Bearing Guide

Priced From
$42.60
-
$56.44
Free shipping on orders $49 and up
SEE OPTIONS BELOW
*Sort the Table by clicking on the Column Heading
DBdLFluteTypeBall BearingReplacement BearingBrandTool NoOur PriceWish ListReady To Buy
3/411/23-1/421/16 Over-hang10°Lower47726
Amana Tool 57153 Carbide Tipped Sink and Trim with Ultra-Glide BB Guide Solid Surface 3/4 D x 1 Inch CH x 10 Deg x 1/2 SHK Router BitMore infoAmana Tool57153$56.80$42.60
Qty:
49/641-1/21/23-1/221/8 Over-hang12°Lower47733
Amana Tool 57155 Carbide Tipped Lansen Stainless Steel Edge Sink and Trim with Ultra-Glide BB Guide Solid Surface 49/64 D x 1-1/2 CH x 12 Deg x 1/2 Inch SHK Router BitMore infoAmana Tool57155$75.25$56.44
Qty:
3/411/23-1/22Flush TrimLower47709
Amana Tool 57154 Carbide Tipped Sink and Trim with Ultra-Glide BB Guide Solid Surface 3/4 D x 1 Inch CH x 1/2 SHK Router BitMore infoAmana Tool57154$56.80$42.60
Qty:
Replacement Ultra-Glide™ Bearing Assemblies Includes #5003 5/32" hex key.
Delrin® is a registered trademark of the Dupont Co.

Trim a sink cutout flush with the bowl in stages using these “over-hang” and flush trim bits in tandem. The overhang bits are equipped with non-marring Ultra-Glide™ bearings that are tapered to match the slope of the bowl’s side.

A first pass with the appropriate overhang bit cleans the cutout edge, leaving a very slight overhang at the underside of the counter. A pass with the flush-trim bit completes the operation.

Carbide-Tipped.
WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.
Copyright © 2020 Toolstoday. All rights reserved.