McAfee Secure. Tested Daily

Fin Lockers CNC Video Using Amana Tool® PCD, Insert & Solid Carbide Router Bits, Designed by Opendesk

© 2017 ToolsToday

For Your Safety

  1. The methods illustrated here are only intended for use with a CNC machine.
  2. Make certain that the workpiece is secured and that all components of the fixture are securely fastened to the table.
  3. Use a guard, eye and hearing protection at all times.

Watch as we create Fin Lockers in 3/4” thick, 11-Ply, Baltic Birch using Amana Tool® industrial solid carbide, insert solid carbide and Polycrystalline Diamond (PCD) tipped CNC router bits in a Shop Sabre 4896 CNC Machine.

Designed as a hub for workspace by Scarlett San Martin for Opendesk, these 48” wide x 44” high x 16” deep lockers can be used as employee storage in an office, a gym locker room or your very own workshop. The Lockers can be grouped together or act as standalone pieces.

Step #1
We cut the legs and other shapes using Amana Tool Solid Carbide Spiral Flute Plunge, Downcut Router Bit #46202.

Step #2
The perimeter of the locker doors and frame are cut using the Amana Tool Polycrystalline Diamond (PCD) Tipped Compression CNC Router Bit with Carbide Plunge Point #DRB-200. The PCD tipped tooling allows for longer cutting life than carbide tipped and solid carbide tooling, provides a consistent component surface finish and is optimized for machine tool efficiency.

Step #3
Lettering to identify each locker is engraved using Amana Tool V-Groove, Miter Fold & Signmaking Insert Solid Carbide CNC Router Bit #RC-1102.

Step #4
Amana Tool’s Compression Solid Carbide Spiral CNC Router Bit #46170 was used to finish the perimeter cuts where the #DRB-200 could not reach due to the larger 1/2” diameter.

Feed, Speed & Step Down Technical Information:

1/4” Diameter Solid Carbide Spiral Flute Plunge, Downcut Router Bit #46202
Feed Rate (IPM): 125"
Speed (RPM): 18,000
Chip Load (Per Tooth): 0.003"
Step Down (Per Pass): 0.250"

1/2” Diameter Polycrystalline Diamond (PCD) Tipped Compression CNC Router Bit with Carbide Plunge Point #DRB-200
Feed Rate (IPM): 150"
Speed (RPM): 18,000
Chip Load (Per Tooth): 0.004"
Step Down (Per Pass): 0.250”

90° V-Groove, Miter Fold & Signmaking Insert Solid Carbide CNC Router Bit #RC-1102
Feed Rate (IPM): 150"
Speed (RPM): 18,000
Chip Load (Per Tooth): 0.004"
Step Down (Per Pass): 0.007”

1/4” Diameter Compression Solid Carbide Spiral CNC Router Bit #46170
Feed Rate (IPM): 125"
Speed (RPM): 18,000
Chip Load (Per Tooth): 0.003"
Step Down (Per Pass): 0.250"

Fin Lockers CNC Video Using Amana Tool Insert and Solid Carbide Router Bits. Designed by Opendesk and CNC cut by ToolsToday, Your Source for Industrial Tooling.

Designed by Scarlett San Martin
http://www.opendesk.cc/fin/fin-lockers

Courtesy of Opendesk
http://www.opendesk.cc


View all tool videos:

minicart.loading