Amana Tool Diamond Tipped PCD Router Bit UP/Down Shear with Carbide Plunge Point RH Rotation in stock and ready to be shipped today. We have a large selection of Diamond Tipped Router Bits available.
Diamond is the hardest material on the earth. Polycrystalline Diamond (PCD) tooling is manufactured in a high-temperature and high-pressure laboratory that fuses diamond particles onto a carbide substrate, which allows the diamond to be brazed onto a tool body.
If you’re looking for the ultimate in tooling, you’ve found it! Amana Tool®'s PCD tipped compression CNC router bits will groove, joint and rabbet a wide variety of tough, abrasive materials including composites, particleboard, MDF (both raw or with melamine), veneer and hardwoods. The cutting edge lasts at least 25 times longer than carbide for extremely long life. Depending on the material being cut, PCD tooling has been known to out perform a carbide tool by a ratio of 300:1. However, to be conservative in your buying decision, we suggest you base your expectations on 25:1 ratio over carbide tooling.
Excellent for cutting:
- Aluminum Composite Material (ACM)
- Composite panels
- Custom composite materials
- Fiberglass PCB board
- Fiber-reinforced urethane
- Fiber-reinforced structural foam floors
- Lightweight composites
- Hard and soft wood