Ogee Raised Panel Router Bits w/ Back Cutter

Similar to standard horizontal raised panel bits, but with back cutter to cut inside of the panel. Includes two different bearings to allow for safer two-pass operation. Carbide Tipped. Use with router table only.

Watch now! How to make Raised Panel Doors by Lonnie Bird

¡WARNING! For Your Safety 1. The methods illustrated here are only     intended for use with a table mounted     router. 2. Do not exceed the recommended RPM for     each of the bits. 3. Use a miter gauge and clamp when     routing the ends of the rails. 4. Use a push block or push stick when     routing the door styles. 5. Use a guard at all times. 6. Use eye and hearing protection. 7. Do not use the methods in this set of     instructions unless you feel that they are      safe for you.  Router Bits shown in video Stile & Rail Router Bits Reversible Stile & Rail Assembly - #55350 2pc Concave Stile & Rail - #55420 & #55421 Raised Panel Router Bits Ogee Raised Panel - #54118 Ogee Raised Panel w/Back Cutter - #54221

Back cutter=1/4" kerf, 5/16" radius cutter. Note: 'A' reflects the total length of cut. Therefore you must deduct (usually 3/8") for allowing the panel to recess into the frame. To receive 'A1' use bearing #47713, which is included.