2-Piece Stile & Rail Router Bit Sets - Concave - 3/4 Inch Material

Our stile and rail sets give you two complete bits, one for doing the rail cuts, one for the stiles. Make cabinet doors and all varieties of frame-and-panel assemblies for furniture and architectural applications.

• For 3/4" material
• Use in a table mounted router

Bits in this set have profile and groove or rabbet cutters and ball-bearing guide mounted on a 1/2" shank. Re-spacing of the components should only be necessary -using the shims provided- after the cutters have been resharpened. Guide straight cuts with the fence; use the pilot bearing only for cuts on curved rails or stiles.

Watch now! How to make Raised Panel Doors by Lonnie Bird

¡WARNING! For Your Safety 1. The methods illustrated here are only     intended for use with a table mounted     router. 2. Do not exceed the recommended RPM for     each of the bits. 3. Use a miter gauge and clamp when     routing the ends of the rails. 4. Use a push block or push stick when     routing the door styles. 5. Use a guard at all times. 6. Use eye and hearing protection. 7. Do not use the methods in this set of     instructions unless you feel that they are      safe for you.  Router Bits shown in video Stile & Rail Router Bits Reversible Stile & Rail Assembly - #55350 2pc Concave Stile & Rail - #55420 & #55421 Raised Panel Router Bits Ogee Raised Panel - #54118 Ogee Raised Panel w/Back Cutter - #54221

 

All 2-Piece stile and rail sets include two complete assemblies consisting of cutters, arbors & bearings.