Home » Shaper Cutters » Do-It-Yourself Beautiful Hardwood Floors Using Tongue and Groove Joints

Do-It-Yourself Beautiful Hardwood Floors Using Tongue and Groove Joints

After many years of having a hardwood floor, one can experience all types of damage. Whether it is light starched, gouges, water damage, boards lifting up…etc. Kids especially put a lot of wear and tear on hardwood floors.

There was one customer I had that lived in an old colonial home in central NJ; a historical and very well-kept beautiful home. The kitchen cabinets were made from old cherry with a gorgeous patina which showed that it lived a very long, yet delicate life. What wasn’t so beautiful, and the reason I was there, were the oak floor boards, which were in shambles, found directly under the sink; obviously damaged through many years of water falling from the sink.

The client needed to have these boards replaced without losing the integrity of the old floor. We decided immediately that factory boards were out of the question. What we needed to do was to locate old growth oak, cut boards from it, create a tongue and groove joint to match the existing boards, install it and then age it to match.

I took a couple of good boards that surrounded the bad ones to my shop. I planed my new boards to thickness and with my shaper and shaper cutters, I was able to get a very close match to the old tongue and groove joints. Just a few minutes of hand work and they were as good as the original boards.

When installing them, I had to keep just one side of one board without a tongue for the board needed to drop in. With a strong adhesive on the bottom, it would sit secure for another century or two.
Now was the fun part. Not only did I need to match the patina, but also the color and finish. After playing around with color pigments, I was able to get something very close. After coloring it, I took out my keys and began to throw and scrape them a bit until I gained the amount of wear which had built up for so many years. Good as new (or old)!

This entry was posted in Shaper Cutters and tagged , , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>